Activities of Ivan ŠTEFANEC related to 2021/0105(COD)
Plenary speeches (1)
Machinery products (A9-0141/2022 - Ivan Štefanec) (vote)
Reports (1)
REPORT on the proposal for a regulation of the European Parliament and of the Council on Machinery products
Amendments (3)
Amendment 167 #
Proposal for a regulation
Article 3 – paragraph 1 – point 3
Article 3 – paragraph 1 – point 3
(3) ‘safety component’ means a physical or digital component, including software, of a machinery which servesproduct which is designed or intended to fulfil a safety function and which is independently placed on the market, the failure or malfunction of which endangers the safety of persons but which is not necessary in order for the machinery to function or may be substituted by normal components in order for the machinery to function. In the case of software of machinery serves to fulfil a safety function, the required hardware is covered by the conformity assessment procedure and specified in the instructions;
Amendment 218 #
Proposal for a regulation
Article 10 – paragraph 3
Article 10 – paragraph 3
3. Manufacturers shall keep the technical documentation and the EU declaration of conformity, where relevant, at the disposal of the market surveillance authorities for ten years after the machinery product has been placed on the market. Where relevant, the source code or programmed logic included in the technical documentation shall be made available upon a reasoned request from the competent national authorities provided that it is necessary in order for those authorities to be able to check compliance with the essential health and safety requirements set out in Annex III.
Amendment 269 #
Proposal for a regulation
Article 22 – paragraph 2
Article 22 – paragraph 2
2. Where relevant, the manufacturer of partly completed machinery or the manufacturer’s authorised representative shall make available to the competent national authority upon its request the source code or programmed logic included in the technical documentation referred to in paragraph 1, point (a), , provided that it is needed in order for that authority to be able to check compliance with the essential health and safety requirements set out in Annex III. The assembly instructions referred to in paragraphs 1, point (b), and the declaration of incorporation referred to in paragraph 1, point (c), shall accompany the partly completed machinery until it is incorporated into the final machinery product and shall afterwards form part of the technical file for that machinery product.